Alcatel-Lucent 1665 Installation Manual page 316

WDMX setup and testing: integration procedures
........................................................................................................................................................................
................................................................................................................................................
3
Login to the Alcatel-Lucent 1665 DMX using the WaveStar
................................................................................................................................................
4
Provision the PTM
Select Configuration > Equipment from the System View
................................................................................................................................................
5
Click the "+" next to XM10G/8 circuit pack to expand the list.
................................................................................................................................................
6
Highlight the Port x and click Select.
................................................................................................................................................
7
Set the Signal type to match the PTM type, using the pull down window (for example if
the PTM is a OC48SR1-I1, set the Signal Type to OC48) and click Apply.
................................................................................................................................................
8
Connect the fibers from Main 1/Main2 to the PTM in the LNW705 while observing proper
optical levels, fiber cleaning procedures and fiber routing in the shelf.
................................................................................................................................................
9
Repeat
Result:
alarms cleared between the nodes.
................................................................................................................................................
10
If configuring the other direction, repeat
................................................................................................................................................
11
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW785/OC192
The LNW785 span is established and tested using the
channel OMD" (p. 9-4)
the WDMX circuit pack. Main 1 is always referred to as the West direction, while Main 2
is the East
........................................................................................................................................................................
9 - 1 2
Step 1 to Step 8 at the other end of the circuit.
Once both ends are completed the Mains should go into service and LOS
S
F T E P S
procedure. In some instances, only one direction may be added to
Step 1 to Step
Table I-3, Installation acceptance checklist
"Turn-up and test the LNW785 8-
Connecting the ring (Mains) to the WDMX
®
CIT.
9.
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010