Alcatel-Lucent 1665 Installation Manual page 197

Software download and circuit pack installation
............................................................................................................................................................................................................................................................
Steps
........................................................................................................................................................................................................................
1
Connect the PC Serial cable to the RS232 (Serial) jack on the front of the SYSCTL circuit
pack. Or connect a PC LAN cable (cross-over) to the LAN (OSI) connector on the front of
the SYSCTL circuit pack.
Note:
Otherwise, you may experience login problems. To assign an IP address, start the DOS
prompt on the computer, and type the command ipconfig/all. The command will show
an IP address line. If there is no address line or 0.0.0.0 for an IP address, then you must
assign an IP address to the NIC card of the computer.
........................................................................................................................................................................................................................
2
Start the WaveStar
was created by the installation procedure.
The following windows appear:
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
An IP address must be assigned to the NIC card on the PC or laptop.
®
CIT software on the PC by double clicking on the WaveStar
®
Use of WaveStar CIT software
®
icon that
5 - 7