Physical installation
............................................................................................................................................................................................................................................................
Figure 2-8 Power connection
........................................................................................................................................................................................................................
5
Route the power cable out of the bay and toward the BDCBB or BDFB, stacking the cable
in the bay as shown in
Figure 2-10, "Power cable routing without cable bracket" (p.
Note:
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
NOTICE
Equipment damage
Ensure that the 4 pins inside the connector attached to the power cable are
properly aligned before inserting the connector into the power connector
housing. Failure to do so may result in damage to the connector.
POWER
CABLE
HOUSING MOUNTING
POSITION
Figure 2-9, "Power cable routing with cable bracket" (p. 2-16)
The Alcatel-Lucent 1665 DMX high-capacity shelf is powered by -48 V DC.
Power cable and cable bracket installation
POWER CONNECTOR
HOUSING
2-17).
or
2 - 1 5