Alcatel-Lucent 1665 Installation Manual page 257

Installation tests
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
9
Choose the correct port on the OC-48 CP and click Select.
........................................................................................................................................................................................................................
10
Click on Operate and Loopback Type: Facility.
........................................................................................................................................................................................................................
11
Click Apply.
This command creates a facility loopback on the OC-48 port of an OC-48 circuit pack.
........................................................................................................................................................................................................................
12
Verify transmission at the patch panel. There should be no alarms at the test set.
........................................................................................................................................................................................................................
13
Select Fault > Analysis > Loopback...
........................................................................................................................................................................................................................
14
Choose the correct port on the OC-48 CP and click Select.
........................................................................................................................................................................................................................
15
Click on Release.
........................................................................................................................................................................................................................
16
Click Apply.
........................................................................................................................................................................................................................
17
Verify loss of transmission at the patch panel. This should be evident by a SONET alarm
and a loss of pattern alarm.
........................................................................................................................................................................................................................
18
Repeat this section for all OC-48 ports.
........................................................................................................................................................................................................................
19
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
S
F T E P S
Table I-3, Installation acceptance
OC-48 (low-speed) testing
checklist.
6 - 4 7