Removing Provisioning And Equipage From The Lnw705 And Lnw785 - Alcatel-Lucent 1665 Installation Manual

WDMX setup and testing: integration procedures
........................................................................................................................................................................
................................................................................................................................................
11
Click Select and expand the circuit pack list by clicking the "+" next to Main 1, highlight
Port 1 OTU-2 and the port will appear on the right side of the screen, click on the AID to
highlight it then click Select.
................................................................................................................................................
12
Click Select for the Add/Drop port, expand the circuit pack (OMD5/8) and click on the
Port (the port must match Main 1 OTU-2 port) and the port will appear on the right side of
the screen, click on the AID to highlight it then click Select.
................................................................................................................................................
13
Connect the fibers from Main 1/Main2 PTM to the corresponding channel in the LNW785
while observing proper optical levels, fiber cleaning procedures and fiber routing in the
shelf.
................................................................................................................................................
14
Repeat
Result:
alarms cleared between the nodes.
................................................................................................................................................
15
If configuring the other direction, repeat
................................................................................................................................................
16
Check off the appropriate box in
E O
N D
........................................................................................................................................................
Removing provisioning and equipage from the LNW705 and
LNW785
Description
This section provides procedures on how to properly remove provisioning from the
Alcatel-Lucent 1665 DMX shelf once testing is completed and the equipment/ports are no
longer needed. Locate the procedure below to remove the equipment and return the
Alcatel-Lucent 1665 DMX back to the original status.
........................................................................................................................................................................
9 - 1 4
Step 1 to Step 13 at the other end of the circuit.
Once both ends are completed the Mains should go into service and LOS
S
F T E P S
Removing provisioning and equipage from the LNW705 and
Step 1 to Step
Table I-3, Installation acceptance
14.
checklist.
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
LNW785
July 2010