Alcatel-Lucent 1665 Installation Manual page 176

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
........................................................................................................................................................................................................................
6
Place the second LNW80 circuit pack into the M2 slot on the Alcatel-Lucent 1665 DMX
high-capacity shelf. Do NOT engage the circuit pack in the backplane connector.
Important!
to provide proper air flow for cooling. Always use Main-1 (M1) for shelves equipped with
only one main pack.
........................................................................................................................................................................................................................
7
Check off the appropriate box in
E O
N D
........................................................................................................................................................
LNW785 OMD5/8 8-channel low-loss DWDM Optical mux/demux
Follow this procedure to install the LNW785 circuit packs in the Alcatel-Lucent 1665
DMX high-capacity shelf. The LNW785 OMD5/8 circuit pack multiplexes/demultiplexes
up to 8 DWDM optical channels spaced 100 GHz apart, ranging from 1530 to 1536 nm.
Note:
with LNW55 OC3/OC12/OC48, LNW82 OC3/OC12/OC48, LNW504 OC-48/OC-
192, LNW785 OMD, and/or LNW705 XM10G/8 circuit packs. This shelf cover
provides more space to prevent fibers from touching the front cover when the cover is
closed.
........................................................................................................................................................................................................................
1
See the engineering job specification. Identify the proper function group slots where
LNW785 circuit packs will be installed.
........................................................................................................................................................................................................................
2
Remove the first LNW785 circuit pack from the packing material.
........................................................................................................................................................................................................................
3
Place the circuit pack into the shelf (slot A1, A2, B1, B2, C1, C2, D1, D2, G1, or G2 as
required). Do NOT engage the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
4
Repeat
............................................................................................................................................................................................................................................................
4 - 1 6
If any of the Main slots are to remain unequipped, install a blank circuit pack
S
F T E P S
A deeper shelf cover (comcode 849068358) is required for shelves equipped
Step 1 through Step 3
Table I-3, Installation acceptance
for each additional LNW785 to be equipped.
Initial circuit pack installation
checklist.
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010