Alcatel-Lucent 1665 Installation Manual page 320

WDMX setup and testing: integration procedures
........................................................................................................................................................................
Delete LNW785 circuit pack
................................................................................................................................................
1
Remove the LNW785 circuit pack from the Alcatel-Lucent 1665 DMX shelf.
................................................................................................................................................
2
Update the Alcatel-Lucent 1665 DMX inventory.
Select Configuration > Update System > Update Inventory
................................................................................................................................................
3
Click Yes to acknowledge the request.
E O
N D
........................................................................................................................................................
Delete low-speed PTM
................................................................................................................................................
1
Remove Low Speed PTM from LNW705 by reversing the procedure in
"Install pluggable transmission modules" (p.
................................................................................................................................................
2
If removing the LNW705 from the shelf proceed to
otherwise provision the port back to Signal Type Not Available.
STNA Select Configuration > Equipment
................................................................................................................................................
3
Click the "+" next to the XM10G/8 that had the PTM installed to expand the list.
................................................................................................................................................
4
Locate the port where the PTM was installed and highlight the port and click Select.
................................................................................................................................................
5
After the screen on the right appears, provision the Signal Type to STNA by using the pull
down arrow and select STNA then Apply then Close.
E O
N D
........................................................................................................................................................
Delete LNW705 circuit pack
................................................................................................................................................
1
Remove the LNW705 circuit pack from the Alcatel-Lucent 1665 DMX shelf.
........................................................................................................................................................................
9 - 1 6
S
F T E P S
S
F T E P S
Removing provisioning and equipage from the LNW705 and
E-3).
Delete LNW705 circuit pack (p.
LNW785
Appendix E,
9-16),
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010