Alcatel-Lucent 1665 Installation Manual page 274

Operational tests
........................................................................................................................................................................
................................................................................................................................................
1
Establish a CIT session by following the procedure under
software" (p. 5-6)
................................................................................................................................................
2
Select View > Cross-Connections.
................................................................................................................................................
3
Choose shelf (Alcatel-Lucent 1665 DMX) and click Select.
................................................................................................................................................
4
Verify that the cross-connection entered in the previous section is on the list. If the cross
connect exist proceed to
................................................................................................................................................
5
Select Configuration > Cross-Connections.
................................................................................................................................................
6
Use the Cross-Connection Wizard to enter a new cross-connection at the STS-1 rate,
UPSR Ring Add/Drop, between m1-1-1 and fn1-1 (fn will be a,b,c or d depending on the
slot where the DS1, DS3, or TMUX CP is located).
This command creates a cross-connection to map 28 DS1s of a DS1 circuit pack or the
first DS3 of a DS3/EC1 or TMUX circuit pack in a Function unit slot(s) to the first STS-1
of the Main OLIUs.
................................................................................................................................................
7
Select View > Protection.
................................................................................................................................................
8
Under Path Protection choose m-1-1.
................................................................................................................................................
9
Click Select.
................................................................................................................................................
10
Note the Active Path: (m1-1-1 or m2-1-1).
The M1 OLIU is associated with Ring 1 and the M2 OLIU is associated with Ring 2.
................................................................................................................................................
11
Disconnect the optical fiber connected to the IN port of the OLIU that is the active
receiver.
........................................................................................................................................................................
7 - 8
in Chapter 5, "Software download and circuit pack
Step 7; otherwise, continue to establish a cross connection.
Automatic protection switching and alarm test
"Use of WaveStar
installation".
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
®
CIT
July 2010