Software Download And Circuit Pack Installation; Software Installation - Alcatel-Lucent 1665 Installation Manual

Software download and circuit pack installation

............................................................................................................................................................................................................................................................
PC minimum requirements
It is anticipated that most customers will dedicate a laptop or personal computer (PC) to
run the WaveStar
suffice. The minimum PC requirements are found in
following table shows the requirements for the computer:

Software installation

Description
Software installation is accomplished by performing the appropriate software download
procedures in the
Description
When the software installation is complete check off the appropriate box in
Installation acceptance
Circuit pack installation
Description
This section provides instructions and the recommended order for installing (fully seating)
the circuit packs in the Alcatel-Lucent 1665 DMX shelf. The procedures in this section
assume that the SYSCTL is installed and software has been successfully downloaded as
described in the section,
Locations of circuit packs (Function unit slots) are shown in
initial circuit pack
shelf" (p.
Circuit packs are keyed to prevent being inserted into the wrong shelf position. Installing
circuit packs requires some force.
............................................................................................................................................................................................................................................................
5 - 2
®
CIT software. However, any properly configured computer will also
Alcatel-Lucent 1665 Data Multiplexer (DMX) Release 9.0.0 Software Release
which is shipped with the software.
checklist.
"Software installation" (p.
installation",
4-9).
NOTICE
Laser safety
When connecting fiber loops between the IN and OUT ports on optical circuit
packs, always connect to the IN port first and then the OUT port. This will
prevent any optical radiation from being present at the fiber end.
Table I-2, Computer requirements
5-2).
Figure 4-2, "Alcatel-Lucent 1665 DMX high-capacity
Software installation
Table I-3,
Chapter 4, "Powering and
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010