Iao Lan And Tcp/Ip Cable Installation - Alcatel-Lucent 1665 Installation Manual

Cable and fiber installation
............................................................................................................................................................................................................................................................

IAO LAN and TCP/IP cable installation

Description
This section describes how to connect the IAO LAN/TCP-IP (LAN 10BaseT) cable to the
Alcatel-Lucent 1665 DMX high-capacity shelf and to the interfacing equipment. Perform
this procedure if this cabling is required.
The Alcatel-Lucent 1665 DMX high-capacity shelf supports an IntraOffice LAN (IAO
LAN) interface for operations data communications to support operations systems such as
the Navis Optical Management System (OMS).
Since the IAO LAN can be provisioned as an extension of the SONET DCC, the IAO
LAN can also be used to join multiple, otherwise separate subnetworks.
All NE-to-NE OI features that are supported over the DCC are also supported over the
IAO LAN.
The IAO LAN/TCP-IP interface cable is available in two configurations (cross-over and
straight-through) and may be connected to either the front or rear of the Alcatel-Lucent
1665 DMX high-capacity shelf. The following tables provide additional information:
Table 3-15, "LAN 10BaseT cable assemblies" (p. 3-42)
•
Table 3-16, "LAN 10BaseT cross-over cable connections" (p. 3-43)
•
Table 3-17, "LAN 10BaseT straight-through cable connections" (p. 3-43)
•
Steps
........................................................................................................................................................................................................................
1
If connecting directly to a PC, use a LAN 10BaseT cross-over cable assembly (see
Table 3-15).
If connecting to a hub, use a LAN 10BaseT straight-through cable assembly (see
Table 3-15).
........................................................................................................................................................................................................................
2
If connecting to the front of the Alcatel-Lucent 1665 DMX high-capacity shelf, connect
the cable to the LAN (RJ45) jack on the SYSCTL circuit pack. See
cable installation to front of Alcatel-Lucent 1665 DMX high-capacity shelf" (p.
If connecting to the rear of the Alcatel-Lucent 1665 DMX high-capacity shelf, connect the
cable to the J16 port (IAO LAN) on the Alcatel-Lucent 1665 DMX high-capacity shelf
backplane. See
Lucent 1665 DMX high-capacity shelf" (p.
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
Figure 3-11, "IAO LAN/TCP-IP cable installation to rear of Alcatel-
IAO LAN and TCP/IP cable installation
3-41).
Figure 3-10, "LAN
3-40).
3 - 3 9