Alcatel-Lucent 1665 Installation Manual page 181

Powering and initial circuit pack installation
............................................................................................................................................................................................................................................................
Note:
installed in slots A2, B2, C2, D2, G2. Always consult the engineering job specification
for placement of circuit packs.
........................................................................................................................................................................................................................
4
If a companion circuit pack is required, continue with
pack into the companion circuit pack slot (A2, B2, C2, D2 or G2 as required), then
proceed to
Note:
for cooling.
........................................................................................................................................................................................................................
5
Remove the second OLIU from the packing material.
........................................................................................................................................................................................................................
6
Place the circuit pack into the shelf (slot A2, B2, C2, D2 or G2 as required). Do NOT
engage the circuit pack in the backplane connector.
........................................................................................................................................................................................................................
7
Repeat
equipped with LNW37, LNW45, LNW49, LNW55 or LNW62 circuit packs.
........................................................................................................................................................................................................................
8
Install the PTM module per
........................................................................................................................................................................................................................
9
Check off the appropriate box in
E O
N D
........................................................................................................................................................
............................................................................................................................................................................................................................................................
Alcatel-Lucent 1665 DMX R9.0
365-372-304R9.0 Issue 2
July 2010
If using VLF mains (LNW59, LNW82, LNW504), the circuit pack may be
Step 7.
Blank circuit packs are required in all unused slots to provide proper air flow
Step 1 through Step 6
Pluggable transmission modules (PTM) (p.
S
F T E P S
for each additional function group and/or growth slot to be
Table I-3, Installation acceptance
Initial circuit pack installation
Step 5. If not, install a blank circuit
E-1).
checklist.
4 - 2 1