Danfoss VACON NX All-in-One Application Manual page 98

VACON® NX All-in-One
Application Guide
Index Parameter
P2.3.1.2
Digital output 1 function
P2.3.1.3
Digital output 1 on delay
P2.3.1.4
Digital output 1 off delay
VACON NXP drives only
®
P2.3.1.5 INV Delayed DO1
P2.3.1.6 ID Bit Free DO1
DO1 Time Scale
P2.3.1.7
Use the Terminal to Function method (TTF) with these parameters, see
1
Table 64: Delayed Digital Output 2 (Control Panel: Menu M2 -> G2.3.2)
Index Parameter
P2.3.2.1
Digital output 2 signal selection
P2.3.2.2
Digital output 2 function
P2.3.2.3
Digital output 2 on delay
P2.3.2.4
Digital output 2 off delay
98 | Danfoss A/S © 2023.02
Min Max Unit Default
-
0 29 1
0.00 320.00 Varies 0.00
0.00 320.00 Varies 0.00
-
0 1 0
-
0.0 200.15 0.0
0 2 - 0
10.626 "Terminal to Function" (TTF) Programming
Min Max
0.1 E.10
0 29
0.00 320.00
0.00 320.00
Multi-purpose Control Application
ID Description
10 = Jogging spd selected
11 = At speed
12 = Mot. regulator active
13 = Freq. limit 1 superv.
14 = Freq. limit 2 superv.
15 = Torque limit superv.
16 = Ref. limit supervision
17 = External brake control
18 = I/O control place act.
19 = AC drive temp. limit superv.
20 = Reference inverted
21 = Ext. brake control inverted
22 = Therm. fault or warn.
23 = On/Off control
24 = Fieldbus DIN 1
25 = Fieldbus DIN 2
26 = Fieldbus DIN 3
27 = Temp.Warning
VACON NXS drives only:
312
®
28 = Temp.Fault
VACON NXP drives only:
®
29 = ID.Bit
-
487
-
488
1587 0 = No
1 = Yes
-
1217
1060
0 = s
1 = min
2 = h
Unit Default ID
-
0.1 489
-
0 490
Varies 0.00 491
Varies 0.00 492
AB296635287482en-000301 / DPD00903
Principle.
Description
-
See P2.3.1.2
-
-