Monitoring Value Descriptions - Danfoss VACON NX All-in-One Application Manual
Hide thumbs
Also See for VACON NX All-in-One:
- Installation manual (5 pages) ,
- Commissioning and maintenance manual (62 pages)
Table of Contents
Advertisement
VACON® NX All-in-One
Application Guide
9 Monitoring Value Descriptions
9.1 (ID 1) Output Frequency
Location in the menu: V1.1
This monitoring value shows the actual output frequency to the motor.
9.2 (ID 2) Motor Speed
Location in the menu: V1.3
This monitoring value shows the actual speed of the motor in RPM (calculated value).
9.3 (ID 3) Motor Current
Location in the menu: V1.4
This monitoring value shows the measured current of the motor.
9.4 (ID 4) Motor Torque
Location in the menu: V1.5
This monitoring value shows the actual torque of the motor (calculated value).
When the torque is in counterclockwise direction, the value is negative.
9.5 (ID 5) Motor Shaft Power
Location in the menu: V1.6
This monitoring value shows the actual shaft power of the motor (calculated value) as a percentage of the motor nominal power.
9.6 (ID 6) Motor Voltage
Location in the menu: V1.7
This monitoring value shows the actual output voltage to the motor.
9.7 (ID 7) DC Link Voltage
Location in the menu: V1.8
This monitoring value shows the measured voltage in the DC link of the drive.
9.8 (ID 8) Unit Temperature
Location in the menu: V1.9
This monitoring value shows the measured heat sink temperature of the drive.
9.9 (ID 9) Motor Temperature
Location in the menu: V1.10.
This monitoring value shows the calculated motor temperature in percentage of the nominal working temperature.
9.10 (ID 13) Analog Input 1
Location in the menu: V1.11
This monitoring value shows the status of the analog input 1.
9.11 (ID 14) Analog Input 2
Location in the menu: V1.12
This monitoring value shows the status of the analog input 2.
9.12 (ID 15) DIN 1, DIN 2, DIN 3
Location in the menu:
•
V1.13 (Basic Application, Standard Application, Local/Remote Control Application, Multi-Step Speed Control Application, Multi-
Purpose Control Application, Pump and Fan Control Application)
•
V1.15 (PID Control Application)
Danfoss A/S © 2023.02
Monitoring Value Descriptions
AB296635287482en-000301 / DPD00903 | 151
Advertisement
Table of Contents
Need help?
Do you have a question about the VACON NX All-in-One and is the answer not in the manual?