Danfoss VACON NX All-in-One Application Manual page 185

VACON® NX All-in-One
Application Guide
Selection Selection name
number
13 Motor potentiome-
ter down
Multi-Step Speed Control Application
13 Preset speed
f
out
DIN3
RUN
STOP
Illustration 34: DIN 3 as DC brake Command Input
A Stop mode = Ramp
B Stop mode = coasting
10.62 (ID 302) Analog Input 2, Reference Offset
Location in the menu:
• P2.15 (Basic Application)
• P2.2.3 (Standard Application)
Use this parameter to set the reference offset for analog input.
Selection num- Selection name
ber
0 No offset: 0–20 mA
1 Offset 4 mA ("living zero")
10.63 (ID 303) Reference Scaling, Minimum Value
Location in the menu:
•
P2.2.4 (Standard Application)
• P2.2.16 (Local/Remote Control Application)
• P2.2.15 (Multi-Step Speed Control Application
• P2.2.2.6 (Multi-Purpose Control Application)
Use this parameter to set extra reference scaling.
See also 10.64 (ID 304) Reference Scaling, Maximum
10.64 (ID 304) Reference Scaling, Maximum Value
Location in the menu:
Danfoss A/S © 2023.02
Description
Contact closed: Reference decreases
until the contact is opened
A
ID515
t
Description
-
Provides supervision of zero level signal. In Standard Application, the response
to reference fault can be programmed with parameter ID 700.
Value.
Notes
-
-
f
B
out
DIN3
RUN
STOP
AB296635287482en-000301 / DPD00903 | 185
Parameter Descriptions
t