Drive Control Parameters (Control Panel: Menu M2 -> G2.4) - Danfoss VACON NX All-in-One Application Manual

VACON® NX All-in-One
Application Guide
Index Parameter
P2.3.6.6 Analog output 2 scale
P2.3.6.7 Analog output 2 offset
Use the Terminal to Function method (TTF) with these parameters, see
1
Table 69: Analog Output 3 (Control Panel: Menu M2 -> G2.3.6)
Index Parameter
P2.3.7.1
(1)
Analog output 3 signal selection
P2.3.7.2
Analog output 3 function
P2.3.7.3
Analog output 3 filter time
P2.3.7.4
Analog output 3 inversion
P2.3.7.5 Analog output 3 minimum
P2.3.7.6 Analog output 3 scale
P2.3.7.7 Analog output 3 offset
Use the Terminal to Function method (TTF) with these parameters, see
1
7.4.5 Drive Control Parameters (Control Panel: Menu M2 -> G2.4)
Table 70: Drive Control Parameters, G2.4
Index Parameter
P2.4.1 Ramp 1 shape
P2.4.2 Ramp 2 shape
P2.4.3 Acceleration time 2
P2.4.4 Deceleration time 2
P2.4.5
(1)
Brake chopper
Danfoss A/S © 2023.02
Min Max
10 1000
-100.00 100.00
10.626 "Terminal to Function" (TTF) Programming
Min Max
0.1 E.10
0 15
0.00 10.00
0 1
0 1
10 1000
-100.00 100.00
10.626 "Terminal to Function" (TTF) Programming
Min Max Unit Default
0.0 10.0 s 0.1
0.0 10.0 s 0.0
0.1 3000.0 s 1.0
0.1 3000.0 s 1.0
-
0 6 0
Multi-purpose Control Application
Unit Default ID
% 100 476
% 0.00 477
Unit Default ID
-
0.1 478
-
5 479
s 1.00 480
-
0 481
-
0 482
% 100 483
% 0.00 484
ID Description
500 0 = Linear
100 = full acc/dec inc/dec tmes
501 0 = Linear
100 = full acc/dec inc/dec tmes
-
502
-
503
504 0 = Disabled
1 = Used when running
2 = External brake chopper
3 = Used when stopped/running
4 = Used when running (no testing)
5 = Used when stopped/running (test only
in ready state)
AB296635287482en-000301 / DPD00903 | 103
Description
1 = 4 mA (2 V)
-
-
Principle.
Description
-
See P2.3.5.2
-
0 = Not inverted
1 = Inverted
0 = 0 mA (0 V)
1 = 4 mA (2 V)
-
-
Principle.