Danfoss VACON NX All-in-One Application Manual page 263

VACON® NX All-in-One
Application Guide
Selection number
10.381 (ID 776) Response to Active Filter Fault
Location in the menu: P2.7.41 (Multi-purpose Control Application, VACON
Use this parameter to set the fault response for the active filter fault.
This parameter defines the response to be triggered when the active filter fault input (set with parameter ID 214) is closed.
See separate VACON NX OPTAF (STO) Board Manual for detailed information on the Safe Disable function. This function is available
®
only if the drive is equipped with VACON
Selection number
0
1
2
3
This parameter is present in VACON
10.382 (ID 784) Ambient Temperature Response
Location in the menu: P2.7.51 (Multi-purpose Control Application, VACON
Use this parameter to select the response for the ambient temperature digital input.
Selection number
0
1
2
10.383 (ID 785) Input Switch Response
Location in the menu: P2.7.52 (Multi-purpose Control Application, VACON
Use this parameter to select the response for the input switch digital input.
Selection number
0
1
2
10.384 (ID 850) Fieldbus Reference Minimum Scaling
Location in the menu: P2.9.1 (Multi-purpose Control Application)
Use this parameter to set scaling to the fieldbus reference signal.
See 10.385 (ID 851) Fieldbus Reference Maximum
10.385 (ID 851) Fieldbus Reference Maximum Scaling
Location in the menu: P2.9.2 (Multi-purpose Control Application)
Use this parameter to set scaling to the fieldbus reference signal.
If both parameters (ID 850 & ID 851) have the same value, the minimum and maximum frequency limits are used for scaling.
Danfoss A/S © 2023.02
option board OPTAF.
®
Selection name Description
No Action No response
Warning Warning
Fault Fault, stop at fault according to parameter ID 506.
Fault, Coast Fault, stop at fault always by coasting.
NXP drives only.
®
Scaling.
Selection name
Run state: Fault
NXP)
®
NXP)
®
Selection name
No Action
Warning
Fault
NXP)
®
Selection name
No Action
Warning
Fault
AB296635287482en-000301 / DPD00903 | 263
Parameter Descriptions