Danfoss VACON NX All-in-One Application Manual page 155

VACON® NX All-in-One
Application Guide
9.42 (ID 57) DIN Status Word 2
Location in the menu: V1.22.11 (Multi-Purpose Control Application in VACON
This monitoring value shows the bit-coded status of the digital input signals.
9.43 (ID 58) Pole Pair Number
Location in the menu: V1.21.15 (Multi-Purpose Control Application, VACON
This monitoring value shows the pole pair number in use.
9.44 (ID 59) Analog Input 1
Location in the menu: V2.21.16 (Multi-Purpose Control Application)
This monitoring value shows the value of the analog input signal as a percentage of the range.
NOTE! The actual measurement range always starts from zero (0). If the input is configured to use 4–20 mA, at 4 mA the shown
value is 20%.
9.45 (ID 60) Analog Input 2
Location in the menu: V2.21.17 (Multi-Purpose Control Application)
This monitoring value shows the value of the analog input signal as a percentage of the range.
NOTE! The actual measurement range always starts from zero (0). If the input is configured to use 4–20 mA, at 4 mA the shown
value is 20%.
9.46 (ID 61) Analog Input 3
Location in the menu: V2.21.18 (Multi-Purpose Control Application)
This monitoring value shows the value of the analog input signal as a percentage of the range.
NOTE! The actual measurement range always starts from zero (0). If the input is configured to use 4–20 mA, at 4 mA the shown
value is 20%.
9.47 (ID 62) Analog Input 4
Location in the menu: V2.21.19 (Multi-Purpose Control Application)
This monitoring value shows the value of the analog input signal as a percentage of the range.
NOTE! The actual measurement range always starts from zero (0). If the input is configured to use 4–20 mA, at 4 mA the shown
value is 20%.
9.48 (ID 69) Sensor 4 Temperature
Location in the menu: V1.21.25 (Multi-Purpose Control Application)
This monitoring value shows the measured value of the sensor 4 temperature.
9.49 (ID 70) Sensor 5 Temperature
Location in the menu: V1.21.26 (Multi-Purpose Control Application)
This monitoring value shows the measured value of the sensor 5 temperature.
9.50 (ID 71) Sensor 6 Temperature
Location in the menu: V1.21.27 (Multi-Purpose Control Application)
This monitoring value shows the measured value of the sensor 6 temperature.
9.51 (ID 74) Warning
Location in the menu:
• V1.21.7 (Multi-Purpose Control Application, VACON
•
V1.22.12 (Multi-Purpose Control Application, VACON
This monitoring value shows the warning code of latest activated warning that is not reset.
9.52 (ID 83) Total Current
Location in the menu: V1.32.2 (Multi-Purpose Control Application, VACON
Danfoss A/S © 2023.02
NXP only)
®
NXP only)
®
NXS)
®
NXP)
®
NXP only)
®
Monitoring Value Descriptions
AB296635287482en-000301 / DPD00903 | 155