Itu Output Timing - Hitachi H8/3032 Series Hardware Manual

8.4.9 ITU Output Timing

The ITU outputs from channels 3 and 4 can be disabled by bit settings in TOER or by an external
trigger, or inverted by bit settings in TOCR.
Timing of Enabling and Disabling of ITU Output by TOER: In this example an ITU output is
disabled by clearing a master enable bit to 0 in TOER. An arbitrary value can be output by
appropriate settings of the data register (DR) and data direction register (DDR) of the
corresponding input/output port. Figure 8-54 illustrates the timing of the enabling and disabling of
ITU output by TOER.
Downloaded from Elcodis.com electronic components distributor
T
1
ø
Address
TOER
Timer output
ITU output pin
Figure 8-54 Timing of Disabling of ITU Output by Writing to TOER (Example)
T T
2 3
TOER address
ITU output
248
I/O port
Generic input/output