System-Stopped/Cold Replacement Workflow Of A Pcie Card - Fujitsu Oracle SPARC M12-2 Service Manual

Table 4-52 System-Stopped/Cold Replacement Procedure of the XSCFU (continue d)
Work
Order
10
11
12
13
14
15
*1 Before replacing the XSCFU, confirm that the READY LED of the XSCFU is lit in green or off. If the READY
LED of the XSCFU is blinking, wait until the LED stays lit or is turned off.
- If the XSCFU requiring replacement is not running when the physical partition containing the XSCFU is
powered on, perform active/hot replacement.
- If the physical partition containing the XSCFU requiring replacement is off, you can replace the XSCFU even
when it is not running. In that case, proceed to step 5.
*2 If the SD card installed in the maintenance part will be used, this work is not required.
4.6.2 System-Stopped/Cold Replacement Workflow of a
PCIe Card
Before replacing the PCIe card, see
Precautions for FRU
Table 4-53
Table 4-53 System-Stopped/Cold Replacement Procedure of a PCIe Card
Work
Order
1
2
3
4
5
Task
Installing the power cords on all the
SPARC M12-2/M12-2S units
Diagnosing all the SPARC M12-2/M12-2S
units
Confirming that there is no problem with
the replacement XSCFU
Switching the mode switch on the OPNL
to Locked
Powering on the physical partitions
Checking the operating condition of the
system
Replacement."
shows the workflow for system-stopped/cold replacement of a PCIe card.
Task
Checking the operating condition of the
system
Confirming the PCIe card to be replaced
Checking the operation status of the
SPARC M12-2/M12-2S that houses the
PCIe card to be replaced
Stopping all physical partitions
Switching the mode switch on the OPNL
to Service
Reference
"10.1.1 Installing a Power
"10.5.1 Diagnosing the SPARC M12
Hardware"
"10.5.3 Checking the FRU Status After
Maintenance"
"2.3.2 OPNL Control
"10.9.1 Starting the System With an
XSCF Command"
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical
"Precautions for PCIe card
Reference
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical
"8.2 Troubleshooting"
"Table 2-21 PCIe Card Slot LEDs and
Their States"
"9.5.2 Stopping All Physical
"2.3.2 OPNL Control
Chapter 4 FRU Replacement Workflows
Cord"
Function"
Domains"
replacement" in "7.1
Domains"
Partitions"
Function"
133