Fujitsu Oracle SPARC M12-2 Service Manual page 400

11.5 Switching an SD Card
This section describes the procedure for switching the SD card mounted in the XSCFU.
When you do not switch the SD card, skip this work and perform the work described
in "11.6 Installing the
Note - After switching the SD card, return the SD card that is installed in the replacement
XSCFU. Install the card in the faulty XSCFU, and return both the card and the unit together.
11.5.1 Removing an SD Card
1. Remove the SD card protection cover.
Remove the fixing screw (A in
the cover from the XSCFU.
Figure 11-7 Removing the SD Card Protection Cover
Note - Be careful not to drop the fixing screw of the protection cover onto the board. Also,
store the protection cover and the fixing screw in a safe place.
Remove the SD card.
2.
Release the lock by pressing the SD card (1 in
card from the XSCFU (2 in
378 Fujitsu SPARC M12-2/M12-2S Service Manual ･ January 2023
XSCFU."
Figure 11-7) of the protection cover, and remove
Figure 11-8).
A
Figure 11-8), and then remove the