Table of Contents
Advertisement
Remove the HDDBPU.
2.
Pull down the removal lever of the HDDBPU toward you, and pull out the
HDDBPU while holding its handle (A in
Note - When pulling out the HDDBPU, put your hand under it to prevent it from falling.
Figure 16-5 Removing the HDDBPU
16.3.3
Removing the OPNL
This section describes the procedure for removing the OPNL mounted in the HDDBPU.
Note - If you are replacing the OPNL of the SPARC M12-2S, make a note of the set BB-ID
value.
Remove the HDDs/SSDs.
1.
Remove all the HDDs/SSDs mounted in the HDDBPU. If any filler units are
mounted, remove them too. For details, see
Filler
Unit."
Chapter 16 Maintaining the HDD Backplane Unit and Operation Panel
Figure
16-5).
A
"15.3 Removing an HDD/SSD or
425
Advertisement
Table of Contents
