Table of Contents
Advertisement
Figure 18-4 Removing the Crossbar Cable
4.
Remove the XBU.
Loosen the two fixing screws (A in
remove the XBU from the server with the removal levers (B in
For details, see
"20.3 Removing an
Figure 18-5 Removing the XBU
A
5.
Remove the front cover.
For the procedure for removing the front cover, see
Cover."
Note - The serial number of the server is printed on a label affixed on the front cover. Store
this cover such that it is not mixed up with the front covers of other SPARC M12 units.
Remove the FANUs and FANBPU.
6.
Chapter 18 Maintaining the Backplane Unit and PSU Backplane Unit
Figure
18-5) of the removal levers, and
XBU."
A
"9.8.3 Removing the Front
Figure
18-5) open.
B
467
Advertisement
Table of Contents
