Table of Contents
Advertisement
Based on the check result in step 1, set the BB-ID of the SPARC M12-2S to be
added to "02". For details on how to set a BB-ID, see
OPNL
Prepare for the addition of the SPARC M12-2S.
3.
Log in to the master XSCF, and add the SPARC M12-2S to the building block
configuration by using the addfru command.
XSCF> addfru
------------------------------------------------------------------------------
Maintenance/Addition Menu
Please select the chassis including added FRU.
No. FRU
--- ------------------- --------------
1
/BB#0
2
/BB#1
3
/BB#2
4
/BB#3
------------------------------------------------------------------------------
Select [1-4|c:cancel] : 3
------------------------------------------------------------------------------
Maintenance/Addition Menu
Please select the BB or a type of FRU to be added.
1. BB itself
2. PSU
(Power Supply Unit)
------------------------------------------------------------------------------
Select [1,2|c:cancel] : 1
------------------------------------------------------------------------------
Maintenance/Addition Menu
Please select a FRU to be added.
No. FRU
--- ------------------- --------------
1
/BB#2
------------------------------------------------------------------------------
Select [1|b:back] : 1
You are about to add BB#2.
Do you want to continue?[a:add|c:cancel] : a
Please execute the following steps:
1) After the added device is connected with the system,
please turn on the breaker of the BB#2.
2) Please select[f:finish] :
334
Fujitsu SPARC M12-2/M12-2S Service Manual ･ January 2023
Functions."
Status
Normal
Normal
Unmount
Unmount
Status
Unmount
"2.3 Understanding the
← (*1)
← (*2)
← (*3)
← (*4)
← (*5)
Advertisement
Table of Contents
