Fujitsu Oracle SPARC M12-2 Service Manual page 340

9.7 Removing the SPARC M12-2S
Note - When removing the SPARC M12-2S due to a change in the building block configuration,
be sure to perform the procedure described below.
This section describes the procedure for releasing the SPARC M12-2S from a building
block configuration.
Before removing the SPARC M12-2S, make sure that it is not assigned to any physical
partition.
For details on the commands used here, see the Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 XSCF Reference Manual of the XCP version used.
1. Log in to the master XSCF.
After logging in to the XSCF shell, you can check whether it is in the master
state, by using the showbbstatus command.
XSCF> showbbstatus
BB#00 (Master)
XSCF>
*1 If the XSCF you have logged in to is in the standby state, Standby is displayed.
Check the status of the target SPARC M12-2S.
2.
Log in to the master XSCF, and check that the target SPARC M12-2S is not used.
XSCF> showboards -a -v
PSB R PPAR-ID(LSB) Assignment
---- - ------------ ----------- ---- ---- ---- ------- --------
00-0 00(00)
01-0 00(01)
02-0 SP
XSCF>
*1 If Available or Unavailable is not displayed under Assignment, release the PSB from the physical partition.
3. Delete the CPU Activation key.
Delete the CPU Activation key of the target SPARC M12-2S.
Regarding CPU resources assigned to logical domains, release from the logical
domains the assignment of as many CPU resources as the number of CPU
Activation keys to be deleted. After that, delete the CPU Activation keys.
For details, see "Chapter 5 CPU Activation" in the Fujitsu SPARC M12 and
Fujitsu M10/SPARC M10 System Operation and Administration Guide.
318 Fujitsu SPARC M12-2/M12-2S Service Manual ･ January 2023
← (*1)
Pwr Conn Conf Test
Assigned y y
Assigned y y
Available n n
Fault
y Passed Normal
y Passed Normal
n Passed Normal ← (*1)