Table of Contents
Advertisement
12.3
Removing a PCIe Card
This section describes the procedure for removing a PCIe card.
Note - Unless otherwise noted, the model used in the figures shown in the following
procedures is the SPARC M12-2S.
12.3.1
Enabling the Removal of a PCIe Card
1.
Release the PCIe card from the system.
Note - When you add a PCIe card or perform maintenance in the inactive or system-stopped
state, this step is not necessary.
Note - To release a PCIe card from an active system by using PCI Hot Plug or PPAR DR, you
need to make sure that the I/O resource of the PCIe card to be released or the I/O resource of
the SPARC M12-2S to be released is not assigned to a logical domain. For details, see
Releasing I/O Resources From a Logical
Related to Logical Domain Configurations" in the Fujitsu SPARC M12 and Fujitsu M10/
SPARC M10 Domain Configuration Guide.
2.
Lower the cable support.
For details on handling the cable support, see
Support."
Figure 12-3 Lowering the Cable Support
Remove the cable connected to the PCIe card.
3.
Domain" or "3.2 Operations and Commands
"9.8.1 Lowering the Cable
Chapter 12 Maintaining PCIe Cards
"9.3
387
Advertisement
Table of Contents
