Table of Contents
Advertisement
Note - When you have removed a PCIe card, this step is not necessary.
Return the cable support to the original position.
7.
Return the cable support to the original position, and then secure it with two
screws.
Figure 12-14 Securing the Cable Support
12.4.2
Incorporating a PCIe Card Into the System
This section provides an overview of the procedure for incorporating a PCIe card
into the system after PCIe card replacement or addition. For details, see
Incorporating the SPARC M12-2S or an I/O Device Into the
Operations and Commands Related to Logical Domain Configurations" in the Fujitsu
SPARC M12 and Fujitsu M10/SPARC M10 Domain Configuration Guide.
1.
Incorporate the PCIe card into the physical partition.
When incorporating the PCIe card in the active state, use PCI Hot Plug. For
details, see
Using the Hot Plug
Assign the I/O resource to a logical domain.
2.
Assign the I/O resource as appropriate for the I/O configuration of the logical
domain used. For details, see
Domain."
3.
Save the configuration information of the logical domain.
If there has been any change to the I/O resources of the logical domain in such a
case as when you have added or removed a PCIe card or changed the mounting
location of a PCIe card, be sure to save the logical domain configuration
394
Fujitsu SPARC M12-2/M12-2S Service Manual ･ January 2023
"10.6.2 Incorporating an I/O Device Into the Physical Partition by
Function."
"10.7 Incorporating I/O Resources Into a Logical
"10.6
PPAR" or "3.2
Advertisement
Table of Contents
