Table of Contents
Advertisement
-
4.6.6 System-Stopped/Cold Replacement Workflow of the HDD/SSD
[When adding an HDD/SSD with the server in the hot state]
-
5.1.2 Active/Hot Addition Workflow of the HDD/SSD
-
5.3.2 Inactive/Hot Addition Workflow of the HDD/SSD
-
5.5.2 System-Stopped/Hot Addition Workflow of the HDD/SSD
[When adding an HDD/SSD with the server in the cold state]
-
5.2.2 Active/Cold Addition Workflow of the HDD/SSD
-
5.4.2 Inactive/Cold Addition Workflow of the HDD/SSD
-
5.6.2 System-Stopped/Cold Addition Workflow of the HDD/SSD
[When removing an HDD/SSD with the server in the hot state]
-
6.1.2 Active/Hot Removal Workflow of the HDD/SSD
-
6.3.2 Inactive/Hot Removal Workflow of the HDD/SSD
-
6.5.2 System-Stopped/Hot Removal Workflow of the HDD/SSD
[When removing an HDD/SSD with the server in the cold state]
-
6.2.2 Active/Cold Removal Workflow of the HDD/SSD
-
6.4.2 Inactive/Cold Removal Workflow of the HDD/SSD
-
6.6.2 System-Stopped/Cold Removal Workflow of the HDD/SSD
Caution - Before you handle any unit, be sure to wear a wrist strap to ground any
static electricity. If you perform this procedure without a wrist strap, individual
components or the overall system may be seriously damaged. For details, see
Precautions on Static
15.3
Removing an HDD/SSD or Filler Unit
This section describes the procedure for removing an HDD/SSD or an HDD/SSD filler
unit. To remove an HDD/SSD, use the same procedure.
15.3.1
Removing an HDD/SSD
1.
Open the removal lever of the HDD/SSD.
Pinch the latch (A in
Electricity."
Figure
15-2), and open the removal lever of the HDD/SSD.
Chapter 15 Maintaining Internal Storage
"1.5
415
Advertisement
Table of Contents
