Active/Cold Replacement Workflow Of The Hdd/Ssd - Fujitsu Oracle SPARC M12-2 Service Manual

Table 4-12 Active/Cold Replacement Procedure of the FANBPU (continued)
Work
Order
6
7
8
9
10
11
12
13
4.2.6 Active/Cold Replacement Workflow of the
HDD/SSD
You can perform active/cold replacement of the HDD/SSD in the following
configuration:
Configuration connecting two or more SPARC M12-2S units to a physical partition
■
Before replacing the HDD/SSD, see
Precautions for FRU
Table 4-13
Task
Releasing the SPARC M12-2S requiring
maintenance from the building block
configuration
Placing the SPARC M12-2S requiring
maintenance into the cold state, and
removing the FANBPU from the SPARC
M12-2S
Installing the FANBPU in the SPARC
M12-2S, and placing the SPARC M12-2S
that required maintenance into the hot
state
Incorporating the SPARC M12-2S that
required maintenance into the building
block configuration
Confirming that there is no problem with
the replacement FANBPU
Incorporating the SPARC M12-2S that
required maintenance into the physical
partition
Incorporating I/O resources of the SPARC
M12-2S requiring maintenance into a
logical domain
Checking the operating condition of the
system and the I/O device usage status
Replacement."
shows the workflow for active/cold replacement of the HDD/SSD.
Reference
"9.6.1 Releasing the SPARC M12-2S
From the Building Block
"9.8.2 Removing the Power
"14.3 Removing a FANU or the
FANBPU"
"14.4 Installing a FANU or the
"10.4.1 Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
"10.5.3 Checking the FRU Status After
Maintenance"
"10.6.1 Incorporating the SPARC
M12-2S Into the Physical Partition Using
PPAR DR"
"10.7 Incorporating I/O Resources Into a
Logical Domain"
"9.2 Checking the Operation Status and
Resource Usage Status of Oracle
"Precautions for HDD/SSD
Chapter 4 FRU Replacement Workflows
Configuration"
Cords"
FANBPU"
Solaris"
replacement" in "7.1
83