Table of Contents
Advertisement
Chapter 5
FRU Addition Workflows
This chapter describes addition workflows by type of maintenance for FRUs and the
PCI expansion unit mounted to the SPARC M12. For the installation and removal
procedures of each FRU, see
Active/Hot Addition Workflows
■
Active/Cold Addition Workflows
■
Inactive/Hot Addition Workflows
■
Inactive/Cold Addition Workflows
■
System-Stopped/Hot Addition Workflows
■
System-Stopped/Cold Addition Workflows
■
5.1
Active/Hot Addition Workflows
This section describes the workflows for active/hot addition of FRUs to the SPARC
M12.
Before performing addition work, be sure to check the notes on maintenance work in
the Fujitsu SPARC M12 Product Notes of the XCP version used.
Each of the following sections puts together the order of work and the tasks for each
FRU into a table. For details on each task, see the reference shown in the table.
The following FRUs are subject to active/hot addition:
PCIe card
■
HDD/SSD
■
PCI expansion unit
■
Chapter 11
and subsequent chapters.
151
Advertisement
Table of Contents
