Table of Contents
Advertisement
Table 9-1 I/O Resources Released From Logical Domains
I/O Resource
Virtual I/O
SR-IOV virtual
function
PCIe endpoint
Root complex
For details on the commands used here, see "3.2 Operations and Commands
Related to Logical Domain Configurations" in the Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 Domain Configuration Guide and the manual for the software being
used.
If the hotplug service of Oracle Solaris is disabled, enable it by following the
procedure below, and then release the I/O resources.
Check the status of the hotplug service.
1.
# svcs svc:/system/hotplug:default
STATE
disable
Enable the hotplug service.
2.
# svcadm enable svc:/system/hotplug:default
Confirm that the hotplug service is enabled.
3.
# svcs svc:/system/hotplug:default
STATE
online
Note - To perform active maintenance on a FANU, a PSU, or the XSCF unit, the work
described in this section is not required.
272
Fujitsu SPARC M12-2/M12-2S Service Manual ･ January 2023
Not Necessary to Restart Oracle Solaris
or Stop the Domain
"9.3.1 Dynamically Releasing
Virtual I/O From a Logical
Domain"
"9.3.2 Dynamically Releasing
the SR-IOV Virtual Function
From a Logical
Domain"
"9.3.3 Dynamically Releasing
the PCIe Endpoint From a Logical
Domain"
"9.3.4 Dynamically Releasing
the Root Complex From a Logical
Domain"
STIME
FMRI
16:26:10 svc:/system/hotplug:default
STIME
FMRI
16:26:10 svc:/system/hotplug:default
Necessary to Restart Oracle Solaris and
Stop the Domain
-
"9.3.5 Statically Releasing the
SR-IOV Virtual Function From a
Logical
Domain"
"9.3.6 Statically Releasing the
PCIe Endpoint From a Logical
Domain"
"9.3.7 Statically Releasing the
Root Complex From a Logical
Domain"
Advertisement
Table of Contents
