Table of Contents
Advertisement
18.5.1
Installing the PSUBP in the BPU
This section describes the procedure for installing the PSUBP in the BPU.
Note - The system shown in the illustrations provided herein is the SPARC M12-2S. Unless
otherwise noted, the locations of the fixing screws and other details are common to the
SPARC M12-2.
Install the PSUBP in the BPU.
1.
a. Hold the PSUBP horizontal and route the cable through the cable guide of the
b. While holding the PSUBP horizontal, lower it straight with the positioning
Figure 18-17 Installing the PSUBP
b.
BPU.
hole of the PSUBP aligned with the positioning pin of the BPU. Install the
PSUBP in the BPU. Make sure that the fixing screw holes of the PSUBP are
aligned with those of the BPU.
Positioning hole
Positioning pin
Chapter 18 Maintaining the Backplane Unit and PSU Backplane Unit
Cable guide
a.
475
Advertisement
Table of Contents
