Fujitsu Oracle SPARC M12-2 Service Manual page 189

Table 5-12 Inactive/Hot Addition Procedure of a PCI Expansion Unit
Work
Order
1
2
3
4
5
6
7
8
9
10
11
12
13
5.4 Inactive/Cold Addition Workflows
This section describes the workflows for inactive/cold addition of FRUs to the SPARC
M12-2S and inactive/cold addition of the SPARC M12-2S.
Before performing addition work, be sure to check the notes on maintenance work in
Task
Checking the operating condition of the
system
Powering off the physical partition
containing the SPARC M12-2S to which
to add a PCI expansion unit
Switching the mode switch on the OPNL
to Service
Removing the PCICS from the SPARC
M12-2S
Removing the PCIe card filler from the
PCICS
Installing a link card in the PCICS to
install it in the SPARC M12-2S
Connecting a PCI expansion unit to the
link card
Installing a PCIe card in the PCI
expansion unit.
Diagnosing the SPARC M12-2S that has
undergone maintenance
Confirming that there is no problem with
the added PCI expansion unit
Switching the mode switch on the OPNL
to Locked
Powering on the physical partition
containing the SPARC M12-2S that
underwent maintenance
Assigning the I/O resource to a logical
domain
Reference
"9.2.1 Checking the Operation Status of
Physical Partitions and Logical
"9.5.1 Stopping a Specific Physical
Partition"
"2.3.2 OPNL Control Function"
"12.3.1 Enabling the Removal of a PCIe
Card"
"12.3.2 Removing a PCIe Card or PCIe
Card Filler"
"12.4.1 Installing a PCIe Card or PCIe
Card Filler"
"5.2 Connecting Cables to the PCI
Expansion Unit" in the Fujitsu SPARC
M12-2S Installation Guide
"12.4.1 Installing a PCIe Card or PCIe
Card Filler"
"10.5.1 Diagnosing the SPARC M12
Hardware"
"10.5.3 Checking the FRU Status After
Maintenance"
"2.3.2 OPNL Control Function"
"10.9.1 Starting the System With an
XSCF Command"
"3.2 Operations and Commands Related
to Logical Domain Configurations" in the
Fujitsu SPARC M12 and Fujitsu
M10/SPARC M10 Domain Configuration
Guide
Chapter 5 FRU Addition Workflows
Domains"
167