Fujitsu Oracle SPARC M12-2 Service Manual page 110

Table 4-16 Active/Cold Replacement Procedure of the CMU (continued)
Work
Order
3
4
5
6
7
8
9
10
11
12
13
14
15
*1 If the replaced CMUL had the hardware RAID setting enabled, enable the setting again.
*2 If the replaced CMUU was in a SPARC M12-2S with no PCIe cards mounted, or if the CMUL was replaced, no
diagnosis is necessary (because diagnosis was performed in the previous step).
88 Fujitsu SPARC M12-2/M12-2S Service Manual ･ January 2023
Task
Checking the logical domain assignment
status of memory resources mounted in
the SPARC M12-2S requiring maintenance
Releasing I/O resources of the SPARC
M12-2S requiring maintenance from a
logical domain
Releasing the SPARC M12-2S requiring
maintenance from the physical partition
Releasing the SPARC M12-2S requiring
maintenance from the building block
configuration
Placing the SPARC M12-2S requiring
maintenance into the cold state, and
removing the CMU from the SPARC
M12-2S
Installing the CMU in the SPARC
M12-2S, and placing the SPARC M12-2S
that required maintenance into the hot
state
Incorporating the SPARC M12-2S that
required maintenance into the building
block configuration
Diagnosing the SPARC M12-2S with the
replacement CMU (*2)
Diagnosing the XBU and crossbar cable
of the SPARC M12-2S with the
replacement CMU
Confirming that there is no problem with
the replacement CMU
Incorporating the SPARC M12-2S that
required maintenance into the physical
partition
Incorporating I/O resources of the SPARC
M12-2S requiring maintenance into a
logical domain (*1)
Checking the operating condition of the
system and the I/O device usage status
Reference
"3.2.4 Checking the Assignment Status
of Resources" in the Fujitsu SPARC M12
and Fujitsu M10/SPARC M10 Domain
Configuration Guide
"9.3 Releasing I/O Resources From a
Logical Domain"
"9.4.3 Dynamically Releasing the
SPARC M12-2S From the Physical
Partition"
"9.6.1 Releasing the SPARC M12-2S
From the Building Block Configuration"
"17.4 Removing the CMU or
"17.5 Installing the CMU and
"10.4.1 Incorporating the SPARC
M12-2S Into a Building Block
Configuration"
"10.5.1 Diagnosing the SPARC M12
Hardware"
"10.5.2 Diagnosing the XBU and
Crossbar Cable"
"10.5.3 Checking the FRU Status After
Maintenance"
"10.6.1 Incorporating the SPARC
M12-2S Into the Physical Partition Using
PPAR DR"
"10.7 Incorporating I/O Resources Into a
Logical Domain"
"9.2 Checking the Operation Status and
Resource Usage Status of Oracle
Memory"
Memory"
Solaris"