Focusing On A Group Or A Sound - Native Instruments MASCHINE MIKRO MK3 Manual

Undo/Redo on the Controller
Both Take Undo and Step Undo are also available on your controller:
1. To undo a take, press
2. To redo a take, press
3. To undo a step, press
4. To redo a step, press
Take Undo is available in following situations:
▪ Recording in Control mode
▪ Recording in Step mode
▪ Recording modulation
Outside of these three situations, Take Undo has the same effect as Step Undo (see above).
3.3.3

Focusing on a Group or a Sound

To display the content and parameters of a particular Sound or Group, you first need to put it
in focus.
Setting the focus on a Sound or Group is slightly different than selecting it: The focus defines
what will be displayed, whereas the selection defines what will be affected by your edits. Note
that a focused Sound/Group is always selected. The distinction is of importance because you
can select multiple Sounds or Groups to apply your edits to all of them at once! See section
±5.1.3, Selecting Multiple Sounds or Groups
We show here how to put Sounds and Groups in focus when the MASCHINE software is in Arrange
view (default view). For instructions on putting Sounds and Groups in focus in Mix view, please re-
±13.2.3, Selecting Channel
fer to chapter
SHIFT + pad 1 (UNDO).
SHIFT + pad 2 (REDO).
SHIFT + pad 3 (STEP
SHIFT + pad 4 (STEP REDO).
for more on this.
Strips.
UNDO).
MASCHINE MIKRO - Manual - 73
Basic Concepts
Common Operations