Native Instruments MASCHINE MIKRO MK3 Manual page 733

17.2.3 Arming, Starting, and Stopping the Recording
The Start and Cancel buttons.
►
Click Start to arm the recording.
After the recording has been armed, its behavior will depend on the recording mode you have
selected (via the MODE
Mode above):
▪ When recording in Detect mode:
◦ The recording will start as soon as the input signal exceeds the
Until then the
sage appears in the information bar above the waveform display. During this waiting
phase you can also start the recording manually by clicking the
cel the recording by clicking Cancel.
◦ Once the recording has started, click
or Cancel to cancel the recording (the recorded audio will not be saved).
▪ When recording in Sync mode:
◦ The recording will start at the next bar. Until then the
Waiting label and the
bar above the waveform display.
◦ Once the recording has started, the audio is recorded for the duration set by the
LENGTH control (see section
above). You can also click
Cancel to cancel the recording (in that case the recorded audio will not be saved).
▪ When recording in Loop mode:
◦ The recording will start at the beginning of the Pattern. Until then the
reads a flashing
in the information bar above the waveform display.
selector, see section ±17.2.2, Selecting the Source and the Recording
Start button turns to a
Stop
Waiting for the next bar...
±17.2.2, Selecting the Source and the Recording Mode
Stop beforehand to stop the recording at the next bar, or
Waiting label and the
Waiting button and the
to stop the recording (it stops immediately)
Start
message appears in the information
Waiting for end of Pattern...
Sampling and Sample Mapping
Recording Audio
THRESHOLD value.
Waiting for input... mes-
Waiting button or can-
button reads a flashing
Start button
message appears
MASCHINE MIKRO - Manual - 733