Using The Metronome - Native Instruments MASCHINE MIKRO MK3 Manual

²
The recording goes on in Overdub mode (see description above).
You can also erase events without engaging record: If you hold
playing (or recording), all events of that pad at the current play position are deleted (see section
±11.4.5, Deleting
Where are the Events Recorded?
When you start recording the pads, the events are recorded as follows:
▪ If a Pattern is already selected (i.e. loaded in the Pattern Editor), the events are recorded
in that Pattern. This is also true if the playhead of the Arranger currently is within an auto-
matic repetition of the Pattern.
▪ If no Pattern is selected, engaging record (in Overdub or Replace mode) automatically cre-
ates an empty Pattern with the default Pattern Length. The new Pattern is used at the be-
ginning of the current Scene and repeated all along the Scene.
You can adjust the default Pattern Length in the
tion ±3.6.1, Preferences 3 General Page
When you get ready to record, you can also use the Record Prepare mode on your controller to
quickly create a new Pattern with the desired length and directly start the recording! See sec-
tion The Record Prepare Mode for more on this.
11.2.2

Using the Metronome

The metronome will help you to keep time when recording in real time.
►
Click the metronome icon in the MASCHINE Header to enable/disable the metronome:
The metronome can be heard only when the sequencer is playing.
The metronome signal is sent to the Cue bus. To know how to use the Cue bus, see section
±13.2.6, Using the Cue
Events/Notes).
for more information.
Bus.
ERASE together with a pad while
Defaults page of the Preferences
MASCHINE MIKRO - Manual - 423
Working with Patterns
Recording Patterns in Real Time
panel. See sec-