Native Instruments MASCHINE MIKRO MK3 Manual page 427

Hide thumbs Also See for MASCHINE MIKRO MK3:

Table of Contents

to enable/disable the Follow function.

When Follow is enabled, your pads automatically switch to the next 16 steps as soon as

the playback position reaches the end of the portion currently displayed.

This Follow function is always synchronized with the Follow function in the software. See

Following the Playback Position in the Pattern

Otherwise you can manually switch to the previous/next steps:

Turn the Encoder to manually switch to the previous/next 16 steps on your pads.

Doubling Your Pattern

You can quickly double the content of the Pattern:

The length of the Pattern is doubled. All events in the original Pattern are duplicated to

the second half of the extended Pattern. Any events that were located beyond the original

Pattern9s end are moved beyond the extended Pattern9s end.

You can otherwise double your Pattern via Pattern mode 4 see section

for more information.

Preparing the Next Events

You can adjust the velocity of the next events that you will create by pressing the pads. The

velocity of the events you create depends on the state of the Fixed Velocity option:

to enable/disable the Fixed Velocity option.

▪ If Fixed Velocity is enabled, all events you create will have the velocity set by turning the

Control encoder. The Fixed Velocity value is momentarily shown on the display as you turn

the Controller encoder.

▪ If Fixed Velocity is disabled, the velocity of each event will depend on how hard you hit the

pad when creating the event.

for more information.

(Double) to double the content of the Pattern.

Working with Patterns

Recording Patterns with the Step Sequencer

±11.4.9, Doubling a Pattern

MASCHINE MIKRO - Manual - 427

Show Quick Links

Table of Contents