Bass Synth Parameters - Native Instruments MASCHINE MIKRO MK3 Manual

10.1.2

Bass Synth Parameters

Available from the both the Control area of the Arrange view and in the Plug-in Strip of the Mix
view, the parameters are as follows:
The parameters described are presented as they appear in the Control area (Arrange view). The
same parameters are available in the Plug-in panel within the Plug-in Strip (Mix view). See
The Plug-in Strip
Main Page
Element
OSC Section
Shape
Octave
Filter Section
Cutoff
Resonance
Envelope Section
for more information on this.
Description
Adjusts the waveform shape continuously from sine to square. To
adjust the waveform shape, turn the
dragging upwards or downwards. The waveform shape can be
viewed in the Plug-in Strip of the Mix view.
Transposes the base key of the Bass Synth (range: -3 3 3). To
transpose the base key, turn the
dragging upwards or downwards.
Adjusts the frequency of the low-pass filter (range: 14.6 Hz 3 23.7
KHz). To adjust the cutoff frequency, turn the
clicking and dragging upwards or downwards.
Adjusts the amount of boost around the cutoff frequency (range:
0.0% 3 120%), Resonance can start to self-oscillate when
increasing the amount over 100.0 %. To adjust the amount of
resonance, turn the Resonance
upwards or downwards.
Shape knob by clicking and
Octave knob by clicking and
Cutoff knob by
knob by clicking and dragging
MASCHINE MIKRO - Manual - 403
Using the Bass Synth
Bass Synth 3 General Handling
±13.4,