Native Instruments MASCHINE MIKRO MK3 Manual page 291

LFO Controls
Type
Speed
Phase
Sync
DESTINATION
This is where you define modulation targets for the LFO, i.e. the parameters you want this LFO
to control. The knobs adjust the amount of modulation for the following targets:
Parameter
Pitch
Cutoff
Drive
Pan
Description
Here you can choose the shape of the LFO waveform. Available
shapes are Sine, Tri (Triangle), Rect (Rectangle), Saw, and Random.
Controls the rate of the LFO measured in hertz (Hz). If you choose to
synchronize the Speed
instead of hertz.
Defines the initial phase of the LFO waveform, from -0.50 to 0.50.
The Sync selector is used to synchronize the LFO with the tempo of
your Project. If Free is selected, the LFO rate is independent of the
Project tempo. If Retrig or Lock is enabled, the values of the
parameter will change into note values ranging from 16/1 (= one
modulation cycle in 16 bars) to 1/32 (one cycle in 1/32nd note) and
be synced with the Project tempo. While Retrig restarts the LFO at
each new note (each note has another LFO phase), Lock keeps the
LFO phase synchronized to the song position for all notes.
Modulation Destination
Tune parameter of the PITCH / GATE
page (page 2).
Cutoff parameter of the
BP2 only) on the FX / Filter
Drive parameter of the FX
Pan parameter on the Audio
(see ±12.1.2, Configuring the Main Output of Sounds and Groups
more information).
by activating Sync, it will show note values
section on the
FILTER section (with filter types LP2, HP2,
page (page 3).
section on the FX / Filter
page of the Sound9s Output properties
Working with Plug-ins
The Sampler Plug-in
Speed
Pitch / Envelope
page (page 3).
for
MASCHINE MIKRO - Manual - 291