Editing Events In Step Mode - Native Instruments MASCHINE MIKRO MK3 Manual

These parameters affect only your next hits on the pads: They don9t modify the velocity of ex-
isting events.
11.3.2

Editing Events in Step Mode

In Step mode you can quickly adjust the parameters of events on particular steps.
Quick Edit Shortcuts for the Selected Steps
You can quickly adjust the velocity, position, and pitch of any events via the Quick Edit short-
cuts:
1. Press and hold the pad(s) of the step(s) you want to edit.
2. To adjust the velocity, press the
3. To finely adjust the position, press the
4. To adjust the pitch, press
²
The adjusted value appears on the display. When you are done, release the pad(s).
Editing Events in Step Mode on the Controller
In Step mode on your controller, each event you create is automatically selected (and the pre-
vious selection is dropped). You can then adjust the pitch and position of this last created
event via the various commands available on your pads while holding
±11.4.4, Editing Selected
and Paste Events/Notes, and
available commands.
VOLUME (Velocity) button and turn the Encoder.
SWING
TEMPO (Tune) button and turn the Encoder.
±11.4.5, Deleting
Events/Notes,
±11.4.7, Quantizing Events/Notes
Recording Patterns with the Step Sequencer
(Position) button and turn the Encoder.
SHIFT
±11.4.6, Cut, Copy,
Events/Notes,
for more information on the
MASCHINE MIKRO - Manual - 428
Working with Patterns
4 see section