Native Instruments MASCHINE MIKRO MK3 Manual page 334

The parameters described below are presented as they appear in the Control area (Arrange view).
The same parameters are available in the Plug-in panel within the Plug-in Strip (Mix view). See
±13.4, The Plug-in Strip
Element
MAIN Section
Engine
Tune
Decay
Snap
Impact
PUNCH Section
Mode
Decay
Amount
Advanced Page
For this engine the Advanced
for more information on this.
Description
Selects the engine used in the Kick Plug-in. If you change this
setting, please refer to
Adjusts the pitch of the drum played by the middle C, measured in
MIDI note numbers and cents. Available values range from 36.00 to
60.00. The default value is 48.00. For more details see
Pitch Range, Tuning, and MIDI
Adjusts the duration of the sound9s tail, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Emulates the air movement caused by the beater before the drum is
hit. Therefore, it produces a snap in the waveform the length of
which can be controlled through this parameter. Available values
range from 0.0 to 100.0 % (default: 50.0 %).
Adjusts how hard the drum is hit, measured as a percentage.
Available values range from 0.0 % (softest) to 100.0 % (hardest).
The default value is 75.0 %.
Selects from two different punch modes: A (default) and B.
Adjusts the duration of the punch, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 50.0 %).
Adjusts the amount of punch, measured as a percentage. Available
values range from 0.0 to 100.0 % (default).
page does not contain any parameters.
±9.2, The
Kicks.
Notes.
MASCHINE MIKRO - Manual - 334
Using the Drumsynths
The Kicks
±9.1.5,