Native Instruments MASCHINE MIKRO MK3 Manual page 746

Parameter
LENGTH (Stretch
Length, Beat mode
with Auto Detection
enabled only)
SPEED
(Free mode only)
In Beat mode, if you set a target tempo that is smaller than a tenth of the original tempo, the
button will be disabled. Set a higher target tempo to enable the
►
Once you have set the parameters to the desired values, click
shifting and/or time stretching to the selected region in the Sample, or
Sample untouched.
17.4 Slicing a Sample
Slicing allows you to chop up loops to extract single Sounds (the drum sounds of a drum loop
for example), but it's also good for preparing a loop to be played back at another tempo without
changing its pitch or timing. The resulting Slices can then be exported to different notes of the
same Sound or to different Sounds of the same Group.
The Slice page of the Sample Editor in the software and its equivalent the
Sampling mode on your controller allow you to slice your Samples in various ways.
The typical workflow for slicing your Samples is as follows:
1. Open the Slice page
2. Choose a method for slicing along with a few settings depending on the chosen method:
±17.4.2, Adjusting the Slicing
Description
If AUTO DTCT is enabled, you can define the length of the target
audio (in bars). Please note that any change to the
(see above) will be automatically mirrored by this
you have set the number of bars in the source audio, you can set here
another number of bars, thereby dividing or multiplying the tempo of
the target audio. Available values are 1/16, 1/8, 1/4, 1/2, 1, 2, 4, and
8 bars, as well as the corresponding triplet values.
Adjusts the new tempo relative to the original tempo (in percentage).
The minimum value is 10 %.
(SLICE page on the controller):
Settings.
Sampling and Sample Mapping
SRC BPM
LENGTH
Apply button again!
Apply to apply the pitch
Cancel
SLICE
±17.4.1, Opening the Slice
MASCHINE MIKRO - Manual - 746
Slicing a Sample
value
value. Once
Apply
to let the
page of the
Page.