Native Instruments MASCHINE MIKRO MK3 Manual page 771

If a loop has been defined in the Sample, it is also indicated on the waveform. You can then
adjust the loop by dragging its borders, and move the entire loop by dragging its title bar.
Loops can be created and adjusted in the
form display (see section
stay within the play range. Therefore, when moving the Sample9s start and end points closer to
each other (see above), keep in mind that it might also shrink the loop!
17.5.6 Adjusting the Zone Settings
At the bottom of the Zone
played back.
The Zone settings in the software.
The various sections always display the values for the focused Zone.
If the MASCHINE window is not wide enough to display all Zone settings at once, a horizontal bar
appears underneath to scroll to the desired section of parameters.
Following parameters are available:
(1) PLAY RANGE section
The parameters in the PLAY RANGE
be played back when the Zone is triggered.
Parameter
START
END
(2) LOOP section
The parameters in the
loop while the note is held.
LOOP
±17.5.6, Adjusting the Zone
page, the Zone settings allow you to adjust how each Zone should be
section allow you to adjust the portion of Sample that will
Description
Adjusts the playback9s start point in the Sample of the focused
Zone.
Adjusts the playback9s end point in the Sample of the focused
Zone.
LOOP section allow you to define and adjust a portion that will play in
section of the Zone settings, under the wave-
Settings). Note that the loop will always
MASCHINE MIKRO - Manual - 771
Sampling and Sample Mapping
Mapping Samples to Zones