Native Instruments MASCHINE MIKRO MK3 Manual page 751

You can directly adjust your Slices manually by selecting Manual in the
from MASCHINE9s proposed Slices as described in section
and fine-adjust these Slices manually 4 in that case the
Manual.
4
3
1
2
5
Manually adjusting your Slices.
(1) Waveform display
Shows the selected Sample with a couple of spread vertical lines in the waveform: this is
where the Slices are going to be applied (i.e. cut).
▪ Hover a Slice with the mouse to select it (it is highlighted). Little <S= and <E= markers ap-
pear at the bottom of the Slice borders to indicate the start and end point of that Slice,
respectively.
▪ Use the scroll wheel of your mouse to zoom in/out. You can also use the zooming scroll bar
(2).
▪ When the entire Sample or a particular Slice is played back, a playhead indicator (white ver-
tical line) shows you the current play position within the waveform.
Sampling and Sample Mapping
MODE selector, or start
±17.4.2, Adjusting the Slicing Settings
MODE selector automatically switches to
MASCHINE MIKRO - Manual - 751
Slicing a Sample