Native Instruments MASCHINE MIKRO MK3 Manual page 374

Element
Bend
Impact
Advanced Page
The Advanced page contains parameters controlling the individual oscillators.
Element
HARMONICS Section
Interval
FM Freq
FM Decay
FM Amount
Description
Adjusts the pitch sweep of the sound, measured as a percentage.
Available values range from -100.0 % to 100.0 % (default: 0.0 %).
At zero the sound stays at its original pitch during its entire
decaying phase. At higher values, the pitch bends upwards. At lower
values, the pitch bends downwards.
Adjusts the amount of attack, measured as a percentage. Available
values range from 0.0 % (soft attack) to 100.0 % (maximum
attack). The default value is 80.0 %.
Description
Adjusts the interval between the two oscillators, measured in
semitones and cents. Available values range from -0.50 to 13.50
(default: 6.50). At low values the oscillators are tuned close
together, giving a detuned sound which can be used for basslines.
Adjusts the frequency of the FM oscillator, measured as a
percentage. Available values range from 0.0 to 100.0 % (default:
50.0 %).
Adjusts the decay of the FM oscillator, measured as a percentage.
Available values range from 0.0 to 100.0 % (default: 35.0 %).
Short decays are useful to supplement the attack or impact of the
tom. Long decays can be used to embellish the tone or timbre of
the tom, especially when applied subtly (see
Adjusts the amount of frequency modulation applied by the FM
oscillator, measured as a percentage. Available values range from
0.0 to 100.0 % (default: 10.0 %). At 0.0 % there is no frequency
modulation so the other FM controls
no effect.
FM Amount below).
(FM Freq and FM Decay) have
MASCHINE MIKRO - Manual - 374
Using the Drumsynths
The Toms