Native Instruments MASCHINE MIKRO MK3 Manual page 363

Hide thumbs Also See for MASCHINE MIKRO MK3:

Table of Contents

TONE Section

Adjusts the pitch of the cymbal played by the middle C, measured

as a percentage. Available values range from 0.0 % to 100.0 %

(default: 50.0 %). For more details see

Tuning, and MIDI

Adjusts the duration of the sound, measured as a percentage. A

short decay produces a closed hat; a long decay gives an open hi-

hat or cymbal. Available values range from 0.0 to 100.0 % (default:

When enabled, the decay of the cymbal is choked by the end of the

note. When disabled (default), the cymbal plays as a one-shot

sound, i.e. until the end of its tail, no matter when the note is

released, although the sound duration will still depend on the

parameter (see above).

Adjusts the center frequency of the filter applied to the sound,

measured in hertz. Available values range from 932.3 Hz to

16.7 kHz (default: 7.4 kHz). The default position gives a standard

metallic analog hi-hat. Colored down, the sound is much more

melodic and in the midrange, good for percussion or effects. In a

way this parameter is a more effective tuning control than the

parameter itself. Note that the

keyboard tracking (i.e. the key/pad you play) along with the

parameter, limited to the range of the parameter.

Adjusts the amount of analog-style saturation applied to the sound

for increased thickness, measured as a percentage. Available values

range from 0.0 to 100.0 % (default: 19.0 %).

Adusts the mix between an oscillator bank and white noise as the

signal source, measured as a percentage. Available values range

from 0.0 % (oscillator bank only) to 100.0 % (white noise only).

The default value is 10.0 %.

±9.1.5, Pitch Range,

parameter also follows

MASCHINE MIKRO - Manual - 363

Using the Drumsynths

Show Quick Links

Table of Contents