Web Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

VLAN_RANGE
configure dhcp helper-address
IP_ADDRESS
configure no dhcp helper-
address
Example:
L2SWITCH#configure terminal
L2SWITCH(config)#interface eth0
L2SWITCH(config-if)#ip address 172.20.1.101/24
L2SWITCH(config-if)#ip address default-gateway 172.20.1.1
L2SWITCH(config)#dhcp relay enable
L2SWITCH(config)# dhcp relay vlan 1
L2SWITCH(config)# dhcp helper-address 172.20.1.1
6.5.2

Web Configuration

Parameter Description
DHCP Relay Settings
State Enables/ disables the DHCP relay for the Switch.
VLAN State Enables / disables the DHCP relay on the specific VLAN(s).
DHCP Server IP Configures the DHCP server's IP address.
Apply Click Apply to take effect the settings.
Refresh Click Refresh to begin configuring this screen afresh.
VLAN or a range of VLANs.
This command configures the DHCP server's IP
address.
This command removes the DHCP server's IP address.
141