Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 181

ptp_config clock-priority1 <Value>
ptp_config no clock-priority1
ptp_config clock-priority2 <Value>
ptp_config no clock-priority2
ptp_config path-trace
ptp_config no path-trace
ptp_config slave
ptp_config no slave
ptp_config two-step-clk
ptp_config no two-step-clk
ptp_config exit
ptp_config end
PTP domain and assigns default clock mode
(Forward) in PTP domain.
This command assigns specified priority for
PTP domain dataset's 1
This command deletes existing 1
from PTP domain clock and assigns default
priority value (128).
This command assigns specified priority for
PTP domain dataset's 2
This command deletes existing 2
from PTP domain clock and assigns default
priority value (128).
This command enables path trace TLV and
adds TLV in list.
This command disables path trace TLV in
domain and deletes it from list.
This command enables PTP domain as slave.
PTP domain will be act as member in PTP
network.
This command disables PTP domain as slave
only. Based on clock data sets it can be act as
either slave or master.
This command enables two step clock mode
in PTP domain.
This command disables two step clock mode
and acts as one step clock as default.
This command provides command prompt
one step as "config" node.
This command provides command prompt as
"enable" node.
181
st
priority.
st priority
nd priority.
nd
priority