Management Host; Cli Configuration - Tripp Lite NGI-M08C4POE8-2 Owner's Manual

Sfp slots managed industrial ethernet poe+ switch
Table of Contents

Advertisement

Apply
Refresh
5.1.4.

Management Host

The feature limits the hosts which can manage the Switch. That is, any hosts can manage the
Switch via telnet or web browser. If user has configured one or more management host, the
Switch can be managed by these hosts only. The feature allow user to configure management IP
based on particular IP or whole subnet.
Notices:
 This feature allows user to configure management host up to 10 entries.
 The default is none, any host can manage the Switch via telnet or web browser.

5.1.4.1. CLI Configuration

Node
Command
enable
show interface eth0
enable
configure terminal
configure
interface eth0
eth0
management host
eth0
show
eth0
management host
A.B.C.D
eth0
management subnet-
host A.B.C.D/M
eth0
no management host
A.B.C.D
Example:
L2SWITCH#configure terminal
L2SWITCH(config)#interface eth0
L2SWITCH(config-if)#management subnet-host 192.168.202.1/24
Success!
L2SWITCH(config-if)#management host 192.168.203.12
select First, Sunday, November and 2:00.
Daylight Saving Time ends in the European Union on the last Sunday
of October. All of the time zones in the European Union stop using
Daylight Saving Time at the same moment (1 A.M. GMT or UTC). So
in the European Union you would select Last, Sunday, October and
the last field depends on your time zone. In Germany for instance, you
would select 2:00 because Germany's time zone is one hour ahead of
GMT or UTC (GMT+1).
Click Apply to take effect the settings.
Click Refresh to begin configuring this screen afresh.
This command displays the eth0 configurations.
This command changes the node to configure node.
This command enters the eth0 interface node to
configure the system configurations.
This command configures a static IP and subnet mask
for the system.
The command displays the all of the interface eth0
configurations.
The command adds a management host address.
The command adds a management host address with
a subnet mask.
The command deletes a management host address.
42
Description

Advertisement

Table of Contents
loading

Table of Contents