Tripp Lite NGI-M08C4POE8-2 Owner's Manual page 210

configure interface range
gigabitethernet1/0/PORTLISTS
if-range spanning-tree(disable|enable)
if-range spanning-tree bpdufilter
(disable|enable)
if-range spanning-tree bpduguard
(disable|enable)
if-range spanning-tree rootguard
(disable|enable)
if-range spanning-tree edge-port
(disable|enable)
if-range spanning-tree cost VALUE
if-range no spanning-tree cost
if-range spanning-tree port-priority <0-
240>
if-range no spanning-tree port-priority
default for the specific port.
This command enters the if-range configure
node.
This command configures enables/disables the
STP function for the specific port.
This command configures enables/disables the
bpdu filter function for the specific port.
This command configures enables/disables the
bpdu guard function for the specific port.
This command enables/disables the BPDU
Root guard port setting for the specific port.
This command enables/disables the edge port
setting for the specific port.
This command configures the cost for the
specific port.
Cost range:
16-bit based value range 1-65535,
32-bit based value range 1-200000000.
This command configures the path cost to
default for the specific port.
This command configures the port priority for
the specific port.
Default: 128.
This command configures the port priority to
default for the specific port.
210